A 1532 XA EVSE adapter

Category: Electric Vehicle Supply Equipment (EVSE) Test kit

Description

Specifications

Weight (KG): 0.9

A 1532 XA Standard set

Instrument XA EVSE adapter
Small soft carrying bag
Instruction manual

The A 1532 EVSE XA adapter is used for verification of electrical safety and functional testing of EVSE together with supported METREL installation testers. It is intended for testing Mode 3 EV supply equipment with a type 2 connector. XA version supports 3 phase load testing up to 13 A and different error types, including PE open. If used together with Metrel AutoSequences®, prebuilt in the newer multifunctional testers, the complete EVSE charging station can be tested (state-by-state) electrically and functionally with a push of a button. It is possible to create a professional station-based report with MESM.

Building LV Installation

EISinsp Competences: Low Voltage Electrical Installation Safety Inspection
EISc Competences: Low Voltage Electrical Installation Safety for Contractors and Maintainers
IEC/EN 61557 Electrical safety in low voltage distribution systems up to 1 000 V AC and 1 500 V DC - Equipment for testing, measuring or monitoring of protective measures - series

Mobile Units Electrical Safety

ISO 6469-3 - Electrically propelled road vehicles Safety specification Part 3: Electrical safety

Electrical Vehicle Supply Equipment

EVSE Competences: Electrical Vehicle Supply Equipment Safety

Key features

Banana socket outputs for connection to a 3-phase installation tester;
Voltage indicators on EVSE output;
Proximity Pilot resistance selector for simulation of EV cable presence and current rating detection;
Control Pilot resistance selector for simulation of electric vehicle status;
Socket output for connection to a 1-phase installation tester (Phase 1, Neutral, PE);
Type 2 Male Plug connector for connection to EVSE;
6 mA EV RCD support;
Functional tests support;*
EVSE AUTO SEQUENCE® support;*
MESM report creation;**
Load testing up to 13 A on socket - 1 phase or on banana sockets - 3 phase;
Fault simulation of Diode short, PE-CP short and PE open;
Output BNC connector for CP signal monitoring.

* Functional tests and AUTO SEQUENCE® are supported only on the MI 3155 Eurotest XD, MI 3152 EurotestXC and MI 3152 H EurotestXC 2.5 kV testers.
** Report printing is only available via the MESM PC SW. The MESM license (P 1101) is to be purchased separately.